#CANON S9000 PRINTHEAD SOFTWARE#Open the printer configuration software and select the USB port.Ĭhoose "Set detination 1" and reset to 1 must be done. Press "resume" once again and the light is green. Press once on "resume", the light turns orange. Press and hold the "Power" button and turn the printer back on. Turn off the printer and disconnect the usb cable. Press the button again for two seconds and release it. Press the button again within 5 seconds and release it. Press the "Resume / reset" button and at the same time reconnect the cable. Press the "resume" button 4 times. The counter is then reset to 0. Release everything and wait until the green light stops flashing: the printer enters "service mode". Release the "resume" button, then press twice on the same button, still holding the "power" button. Press and hold the "resume" button, then do the same with the "power" button. The "resume" button is a circle with an inner triangle pointing down: Note: The ink pad also physically exists in the printer under the print head, and there is a high probability that this pad is saturated with ink.Īlso, the printer is not waterproof, we advise you not to put it on a piece of furniture which could be damaged by ink running under the printer. The solution consists in carrying out a manipulation to reset this used ink counter to zero.ĭepending on your printer, there are different ways to reset the used ink counter. In this case, the manufacturer limits the life of the printer with a maximum number of pages to print. This, even if the printer worked well and printed correctly just before the message appeared. #CANON S9000 PRINTHEAD FULL#If the following message appears, "End of life items or components, contact Canon Support" or "Waste ink tank is almost full or full". #CANON S9000 PRINTHEAD INSTALL#Solution: remove the cartridge, then put it back. Or install another cartridge if it is not recognized. Meaning: the tank cartridge is not correctly installed. Solution: check that the hood is properly closed, that there is no gap or play, even slight. With a soft cloth and a little alcohol, clean part N ° 2 to remove any dust on the electrical contacts.Īfter reinstalling the print head and cartridges, if the fault persists, the only solution is to change the print head or change the printer.Īs an indication, the value of a Canon inkjet printhead is around £65 ex vat. Contact your local Cartridge World store for a quote. Solution: The print head is the block in which you install the reservoir cartridges for your printer.Īn example of a 5-cartridge printhead below without the cartridges.īy lifting the lever on the left, you can then remove the print head. Meaning: the print head is not installed or defective. Remove the cartridge, then put it back. Or install another cartridge if it is not recognized. Solution: open the front panel, and then install the cartridge correctly. Meaning: the tank cartridge is not correctly installed or has run out. Solution: the paper is jammed. Remove the jammed paper, replace the paper correctly in the printer, and then press the Resume / Cancel button. Meaning: the paper exit tray is closed / Paper jam. Solution: Reload paper in the rear tray and press the Resume / Cancel button. Meaning: the printer is out of paper / No paper.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |